HomeFeaturesScreenshotDownloadContactBuy it

 

 

As explained in the Features page, the type of document used by Wave Power is called a chart, and the building blocks of a chart are called components. The screenshot above shows an example of what Wave Power looks like when it is running a chart.

The pale blue area is the chart area. As you can see, this looks like a sort of block diagram. The images, which are connected by black lines in the chart area, represent a group of connected components, in which the outputs of some of the components are connected to the inputs of other components.

You can add a component to a chart by dragging an image from the component panel (the row of images above the chart area) and dropping it onto the chart area. You can connect two components together by dragging the mouse from one to the other.

The components contained in this chart are two Signal Generators, a Balance and a Loudspeaker component, represented by the two red images and the blue and green images respectively. The outputs of the two Signal Generators are connected to the Balance component's inputs (left and right channels), and the Balance's outputs are connected to the inputs of a Loudspeaker component. As a result two tones of different frequencies and different levels can be heard from the left and right loudspeakers connected to your PC.

You can adjust, in real time, the frequencies of the tones and the balance level by using the appropriate controls in the dialog boxes (shown above at the right hand side of the chart area). These dialog boxes also contain other controls which can be used to adjust other settings of the components.

The blue circle at the input of the Loudspeaker component indicates that the frequency spectrum and waveform of the signal at that point are being displayed in the graphs (the two pale yellow areas at the bottom of the screenshot).

 


HomeFeaturesScreenshotDownloadContactBuy it